・Heater cooling
・Precooling for desiccant air processors

*1 The temperature control range noted does not necessarily indicate the actual possible controllable range. The actual
controllable temperature range will differ depending on the air flow and the temperature and humidity of the intake air. For
cooling only. The temperature setting must be lower than the temperature of the air at the inlet port. The compressor will
cycle ON and OFF during times of low loads. The condition of the 8 °C outlet temperature is when the load is less than
the cooling load stated in comment *3.
*2 Values indicated are for when the intake air temperature and pressure are stable and when the ambient temperature is
in the range of 15 to 35 °C, at one point of the discharge port, and indicates the display precision of the controller. Note
that this does not include times of light cooling load when the compressor is cycling ON and OFF.
*3 Conditions of the cooling capacity calculation are as follows: Air flow: 5 m3/min. Outlet temp. and humidity: 8 °C, 100%.
(Enthalpy: 5.92 kcal/kg.) Inlet temperature and humidity: 35 °C, 65%. (Enthalpy: 22.68 kcal/kg.)
*4 Height includes discharge port.
*5 Source voltage phase unbalance should be less than ±3%.
*6 Maximum value within the range of product specifications.
*7 The figure noted is when the product is operating at the highest capacity of its normal operating range.
*8 The external static pressure is when operating under the following conditions: the blower fan operating frequency is 60
Hz, the controlled air outlet port shutter is fully open, and the controlled air discharge-side restricted air flow is 7 m3/min.
Note: All ducting should be insulated and ducting length should be kept as short as possible. (5 m or shorter recommended.)